Cisco 11503 - CSS Content Services Switch User Manual

Chapter 4 Using the CSS Logging Features
Frequently Queried Log Messages
4-56
Cisco Content Services Switch Administration Guide
OL-5647-02
portmapper Subsystem
PORTMAPPER-5: PortUnmap no Port
mapping found.
A source group is running out of
portmappers. Use the portmap
command to increase the portmappers
on the source group so that the message
does not appear, and users or services
do not see a performance or network
address translation problem.
publish Subsystem
PUBLISH-1: Unable to allocate
tree memory <4150000>
The CSS is looking for a segment of
memory that is approximately 4150000
bytes and it cannot locate an available
block of memory. In some cases, this
message may be caused by a
replication misconfiguration. Review
the configuration and verify that it
reflects what was intended. Verify that
files are being replicated properly.
If this message is seen with
significantly smaller memory requests,
the system memory may not sufficient
in size to meet the requirements of the
configuration. To isolate the issue,
monitor the available memory under
non-replication conditions to
determine a baseline and then repeat
this process while replicating to isolate
this issue.
Use the show system-resources
command to view information about
the installed and free memory in the
CSS. To make additional memory
available, reboot the CSS.
Table 4-8 Cisco 11500 Series CSS Log Messages (continued)
Log Message (sys.log: Subsystem
Name, Level, and Message) Cause and Resolution

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English