Hoot and Holler over V3PN Configuration Example
Verify
25
OL-6573-01
The following is an output example for the show voice trunk-conditioning supervisory command,
performed using the configuration on the Headquarters router:
HUB-R1# show voice trunk-conditioning supervisory
SLOW SCAN
0/1/0 : state : TRUNK_SC_CONNECT, voice : on, signal : on ,master
status: trunk connected
sequence oos : no-action
pattern :
timing : idle = 0, restart = 0, standby = 0, timeout = 65535
supp_all = 0, supp_voice = 0, keep_alive = 0
timer: oos_ais_timer = 0, timer = 0
The following is an output example for the show voip rtp connections command, performed using the
configuration on the Headquarters router:
HUB-R1# show voip rtp connections
VoIP RTP active connections :
No. CallId dstCallId LocalRTP RmtRTP LocalIP RemoteIP
1 16 15 20380 19890 192.168.6.2 239.168.1.100
Found 1 active RTP connections
The following is an output example for the show voice call summary command, performed using the
configuration on the Headquarters router:
HUB-R1# show voice call summary
PORT CODEC VAD VTSP STATE VPM STATE
============== ======== === ==================== ======================
0/1/0 g711ulaw y S_CONNECT S_TRUNKED
0/1/1 - - - FXSLS_ONHOOK
The following is an output example for the show class-map command, performed using the
configuration on the Headquarters router:
HUB-R1# show class-map
Class Map match-all control-traffic (id 1)
Match ip dscp af31
Class Map match-any class-default (id 0)
Match any
Class Map match-all video (id 3)
Match ip precedence 4
Class Map match-all voice (id 2)
Match ip dscp ef
The following is an output example for the show policy-map interface atm 1/0 output command,
performed using the configuration on the Headquarters router:
HUB-R1# show policy-map interface atm 1/0 output
ATM1/0: VC 10/100 -
Service-policy output: LLQ
Class-map: control-traffic (match-all)
180010 packets, 43922248 bytes
5 minute offered rate 1000 bps, drop rate 0 bps
To Next Page
Loading...
Need help?
General
