12
Using the ROM Monitor
OL-5997-02
How to Use the ROM Monitor—Typical Tasks
TOTAL: 0X009FAFD8
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 10Mb.
Using 3 percent iomem. [10Mb/256Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(3), RELEASE SOFTWARE
(fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Fri 22-Jul-05 11:37 by hqluong
Image text-base: 0x40098478, data-base: 0x41520000
Port Statistics for unclassified packets is not turned on.
Cisco Router (revision 48.46) with 251904K/10240K bytes of memory.
Processor board ID
2 Gigabit Ethernet interfaces
2 Serial(sync/async) interfaces
2 Channelized T1/PRI ports
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
253160K bytes of USB Flash usbflash1 (Read/Write)
127104K bytes of ATA CompactFlash (Read/Write)
Press RETURN to get started!
*Sep 23 16:11:42.603: %USB_HOST_STACK-6-USB_DEVICE_CONNECTED: A Full speed USB device has
been inserted in port 1.
*Sep 23 16:11:43.011: %LINK-3-UPDOWN: Interface GigabitEthernet0/0, changed state to up
*Sep 23 16:11:43.383: %LINK-3-UPDOWN: Interface GigabitEthernet0/1, changed state to up
*Sep 23 16:11:43.943: %LINK-3-UPDOWN: Interface Serial0/3/0, changed state to down
*Sep 23 16:11:43.947: %LINK-3-UPDOWN: Interface Serial0/3/1, changed state to down
*Sep 23 16:11:43.955: %USBFLASH-5-CHANGE: usbflash1 has been inserted!
*Sep 23 16:11:44.011: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0,
changed state to up
*Sep 23 16:11:44.383: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1,
changed state to down
*Sep 23 16:11:44.943: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/3/0, changed
state to down
*Sep 23 16:11:44.947: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/3/1, changed
state to down
*Sep 23 16:11:46.115: %SYS-5-CONFIG_I: Configured from memory by console
*Sep 23 16:11:46.327: %SYS-5-RESTART: System restarted --
To Next Page
Loading...
Need help?
General
