EasyManuals Logo

Cisco 2800 Series User Manual

Cisco 2800 Series
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #258 background imageLoading...
Page #258 background image
Upgrading the System Image
How to Upgrade the System Image
20
OL-5595-01
Step 12
copy run start
Use this command to copy the running configuration to the startup configuration:
Router# copy run start
Step 13
reload
Use this command to reload the operating system:
Router# reload
Step 14
When prompted to save the system configuration, enter no:
System configuration has been modified. Save? [yes/no]: no
Step 15
When prompted to confirm the reload, enter y:
Proceed with reload? [confirm] y
Step 16
show version
Use this command to verify that the router loaded the proper system image:
Router# show version
00:22:25: %SYS-5-CONFIG_I: Configured from console by console
Cisco Internetwork Operating System Software
.
.
.
System returned to ROM by reload
System image file is "flash:c2600-i-mz.121-14.bin"
What to Do Next
Proceed to the “Saving Backup Copies of Your New System Image and Configuration” section on
page 22.
Loading the New System Image from ROM Monitor Mode
This section describes how to load the new system image from ROM monitor mode.
SUMMARY STEPS
1.
dir flash:[partition-number:]
2.
confreg 0x2102
3.
boot flash:[partition-number:]filename
4.
After the system loads the new system image, press Return a few times to display the Cisco IOS
command-line interface (CLI) prompt.
5.
enable
6.
configure terminal
7.
no boot system
8.
boot system flash new-system-image-filename

Table of Contents

Other manuals for Cisco 2800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2800 Series and is the answer not in the manual?

Cisco 2800 Series Specifications

General IconGeneral
Power SupplyInternal power supply
Product TypeRouter
Form FactorRack-mountable
Connectivity TechnologyWired
Power DeviceInternal power supply
Operating SystemCisco IOS
Integrated ServicesSecurity, voice
WAN InterfacesT1/E1, Serial
LAN InterfacesFast Ethernet, Gigabit Ethernet
Expansion Slots4
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Network/Transport ProtocolIP, TCP
Remote Management ProtocolSNMP, Telnet
FeaturesVPN support, Quality of Service (QoS), VLAN support
Voltage RequiredAC 100-240 V
Security FeaturesFirewall, VPN, Access Control Lists (ACLs)

Related product manuals