Cisco 2800 Series User Manual

IP Communication Solution for Group Applications Configuration Example
Verify
22
OL-6574-01
The following is an example of output for the show voice rtp connections command on the branch
office router:
3845-gw# show voip rtp connections
VoIP RTP active connections :
No. CallId dstCallId LocalRTP RmtRTP LocalIP RemoteIP
1 2 1 32414 20480 10.1.153.42 239.192.17.191
2 4 3 28764 20480 10.1.153.42 239.192.17.192
3 6 5 16416 20480 10.1.153.42 239.192.17.191
4 8 7 27572 20480 10.1.153.42 239.192.17.192
5 1754 1753 16446 20480 10.1.153.42 239.192.17.195
6 1756 1755 31552 20480 10.1.153.42 239.192.17.195
7 1758 1757 16454 20480 10.1.153.42 239.192.17.195
8 1761 1760 16496 20480 10.1.153.42 239.192.17.195
Found 8 active RTP connections
The following is an example of output for the show voip dsp command on the branch office router:
3845-gw# show voip dsp
----------------------------FLEX VOICE CARD 0 ------------------------------
*DSP VOICE CHANNELS*
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABRT PACK COUNT
===== === == ======== ======= ===== ======= === == ========= == ==== ============
C5510 013 01 g711ulaw 4.4.1 busy idle 0 0 0/1/0 00 0 1/419970
C5510 013 02 g711ulaw 4.4.1 busy idle 0 0 0/2/1:2 02 0 15/420330
C5510 013 03 g711ulaw 4.4.1 busy idle 0 0 0/2/1:1 01 0 16/420130
C5510 013 04 g711ulaw 4.4.1 busy idle 0 0 0/1/1 01 0 0/419879
C5510 013 05 None 4.4.1 busy idle 0 0 0/2/0:3 03 0 0/14
C5510 013 06 g711ulaw 4.4.1 busy idle 0 0 0/2/1:3 03 0 1873/1655
C5510 014 01 None 4.4.1 busy idle 0 0 0/2/0:4 04 0 0/14
C5510 014 02 g711ulaw 4.4.1 busy idle 0 0 0/2/1:6 06 0 1833/5379
C5510 014 03 None 4.4.1 busy idle 0 0 0/2/0:5 05 0 0/14
C5510 014 04 None 4.4.1 busy idle 0 0 0/2/0:6 06 0 0/14
C5510 014 05 g711ulaw 4.4.1 busy idle 0 0 0/2/1:5 05 0 1424/5334
C5510 014 06 g711ulaw 4.4.1 busy idle 0 0 0/2/1:4 04 0 1402/5057
*DSP SIGNALING CHANNELS*
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABRT PACK COUNT
===== === == ======== ======= ===== ======= === == ========= == ==== ============
C5510 013 01 {flex} 4.4.1 alloc idle 0 0 0/1/0 02 0 34/0
C5510 013 02 {flex} 4.4.1 alloc idle 0 0 0/1/1 02 0 35/0
C5510 013 03 {flex} 4.4.1 alloc idle 0 0 0/3/1 06 0 14/0
C5510 013 04 {flex} 4.4.1 alloc idle 0 0 0/3/0 06 0 14/0
C5510 013 05 {flex} 4.4.1 alloc idle 0 0 0/3/3 02 0 14/0
C5510 013 06 {flex} 4.4.1 alloc idle 0 0 0/3/2 02 0 14/0
C5510 013 07 {flex} 4.4.1 alloc idle 0 0 0/2/0:1 01 0 4/18
C5510 013 08 {flex} 4.4.1 alloc idle 0 0 0/2/0:2 02 0 4/18
C5510 013 09 {flex} 4.4.1 alloc idle 0 0 0/2/1:1 01 0 27/23
C5510 013 10 {flex} 4.4.1 alloc idle 0 0 0/2/1:2 02 0 27/23
C5510 013 11 {flex} 4.4.1 alloc idle 0 0 0/2/0:3 03 0 454/335
C5510 013 12 {flex} 4.4.1 alloc idle 0 0 0/2/0:4 04 0 465/341
C5510 013 13 {flex} 4.4.1 alloc idle 0 0 0/2/0:5 05 0 433/315
C5510 013 14 {flex} 4.4.1 alloc idle 0 0 0/2/0:6 06 0 421/307
C5510 013 15 {flex} 4.4.1 alloc idle 0 0 0/2/1:3 03 0 3969/3831
C5510 013 16 {flex} 4.4.1 alloc idle 0 0 0/2/1:4 04 0 4050/3933
C5510 014 01 {flex} 4.4.1 alloc idle 0 0 0/2/1:5 05 0 3819/3657
C5510 014 02 {flex} 4.4.1 alloc idle 0 0 0/2/1:6 06 0 3724/3553
------------------------END OF FLEX VOICE CARD 0 ----------------------------
The following is an example of output for the show voice trace command on the branch office router:

Cisco 2800 Series Specifications

General

Power Supply	Internal power supply
Product Type	Router
Form Factor	Rack-mountable
Connectivity Technology	Wired
Power Device	Internal power supply
Operating System	Cisco IOS
Integrated Services	Security, voice
WAN Interfaces	T1/E1, Serial
LAN Interfaces	Fast Ethernet, Gigabit Ethernet
Expansion Slots	4
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Network/Transport Protocol	IP, TCP
Remote Management Protocol	SNMP, Telnet
Features	VPN support, Quality of Service (QoS), VLAN support
Voltage Required	AC 100-240 V
Security Features	Firewall, VPN, Access Control Lists (ACLs)