Cisco 7911G - IP Phone VoIP User Manual

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu
4-10
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
TFTP Server 2 Optional backup TFTP server that the phone
uses if the primary TFTP server is
unavailable.
If neither the primary TFTP server nor the
backup TFTP server is listed in the CTL file
on the phone, you must unlock the CTL file
before you can save changes to the TFTP
Server 2 option. In this case, the phone will
delete the CTL file when you save changes to
the TFTP Server 2 option.
For information about the CTL file, refer to
Cisco Unified Communications Manager
Security Guide. For information about
unlocking the CTL file, see to the “CTL File
Screen” section on page 4-40.
1. Unlock the CTL file, if
necessary.
2. Unlock network configuration
options.
3. Enter an IP address for the
TFTP Server 1 option.
4. Scroll to the TFTP Server 2
option, press the Edit softkey,
and then enter a new backup
TFTP server IP address.
5. Press the Validate softkey, and
then press the Save softkey.
Default Router 1
Default Router 2
Default Router 3
Default Router 4
Default Router 5
Default router used by the phone (Default
Router 1) and optional backup routers
(Default Router 2–5).
1. Unlock network configuration
options.
2. Set the DHCP Enabled option
to No.
3. Scroll to the appropriate
Default Router option, press
the Edit softkey, and then
enter a new router IP address.
4. Press the Validate softkey.
5. Repeat Steps 3 and 4 as needed
to assign backup routers.
6. Press the Save softkey.
Table 4-2 Network Configuration Menu Options (continued)
Option Description To Change

Cisco 7911G - IP Phone VoIP Specifications

General

Brand	Cisco
Model	7911G - IP Phone VoIP
Category	IP Phone
Language	English