Cisco 7911G - IP Phone VoIP User Manual

4-31
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Ethernet Configuration Menu
The Ethernet Configuration menu includes the options that are described in
Table 4-13.
Table 4-13 Ethernet Configuration Menu Option
Option Description To Change
Span to PC Port
(applies to 7911G
only)
Indicates whether the phone will
forward packets transmitted and
received on the network port to the
access port.
Enable this option if an application that
requires monitoring of the phone’s
traffic is being run on the access port.
These applications include monitoring
and recording applications (common in
call center environments) and network
packet capture tools that are used for
diagnostic purposes.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
Forwarding
Delay
(applies to 7911G
only)
Indicates whether the internal switch
begins forwarding packets between the
PC port and switched port on the phone
when the phone becomes active.
• When forwarding delay is set to
disabled, the internal switch begins
forwarding packets immediately.
• When forwarding delay is set to
enabled, the internal switch waits 8
seconds before forwarding packets
between the PC port and the switch
port.
Default is disabled.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.

Cisco 7911G - IP Phone VoIP Specifications

General

Brand	Cisco
Model	7911G - IP Phone VoIP
Category	IP Phone
Language	English