Cisco 7911G - IP Phone VoIP User Manual

4-35
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Table 4-16 Network Configuration Menu Options
Option Description To Change
Load Server Used to optimize installation time for phone
firmware upgrades and offload the WAN by
storing images locally, negating the need to
traverse the WAN link for each phone's upgrade.
You can set the Load Server to another TFTP
server IP address or name (other than the TFTP
Server 1 or TFTP Server 2) from which the
phone firmware can be retrieved for phone
upgrades. When the Load Server option is set,
the phone contacts the designated server for the
firmware upgrade.
Note The Load Server option allows you to
specify an alternate TFTP server for
phone upgrades only. The phone
continues to use TFTP Server 1 or TFTP
Server 2 to obtain configuration files.
The Load Server option does not provide
management of the process and of the
files, such as file transfer, compression,
or deletion.
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
RTP Control
Protocol
Indicates whether the phone supports the Real
Time Control Protocol. Settings include:
• Enabled
• Disabled—default
If this feature is disabled, several call statistic
values display as 0. For additional information,
see the following sections:
• “Call Statistics Screen” section on
page 7-16
• “Streaming Statistics” section on page 8-15
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.

Cisco 7911G - IP Phone VoIP Specifications

General

Brand	Cisco
Model	7911G - IP Phone VoIP
Category	IP Phone
Language	English