Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
4-36
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
CDP: SW Port Indicates whether CDP is enabled on the switch
port (default is enabled).
• Enable CDP on the switch port for VLAN
assignment for the phone, power
negotiation, QoS management, and 802.1x
security.
• Enable CDP on the switch port when the
phone is connected to a Cisco switch.
Note When CDP is disabled in Cisco Unified
Communications Manager, a warning is
presented, indicating that CDP should be
disabled on the switch port only if the
phone is connected to a non-Cisco
switch.
The current PC and switch port CDP values are
shown on the Settings menu.
Use Cisco Unified
Communications Manager
Administration > Device >
Phone.
Table 4-16 Network Configuration Menu Options (continued)
Option Description To Change
To Next Page
Loading...
