3-3
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Understanding the Cisco Unified IP Phones 7906G and 7911G Components
Cisco Unified Communications Manager Configuration
The Cisco Unified IP Phone requires Cisco Unified Communications Manager to
handle call processing. Refer to Cisco Unified Communications Manager
Administration Guide or context-sensitive help in the
Cisco Unified Communications Manager application to ensure that
Cisco Unified Communications Manager is set up properly to manage the phone
and to properly route and process calls.
If you plan to use auto-registration, verify that it is enabled and properly
configured in Cisco Unified Communications Manager before connecting any
Cisco Unified IP Phone to the network. For information about enabling and
configuring auto-registration, refer to Cisco Unified Communications Manager
Administration Guide. Also, see the “Adding Phones to the
Cisco Unified Communications Manager Database” section on page 2-12.
You must use Cisco Unified Communications Manager to configure and assign
features to the Cisco Unified IP Phones. See the “Telephony Features Available
for the Cisco Unified IP Phone” section on page 5-2 for details.
In Cisco Unified Communications Manager, you can add users to the database
and associate them with specific phones. In this way, users gain access to web
pages that allow them to configure items such as call forwarding, speed dialing,
and voice messaging system options. See the “Adding Users to
Cisco Unified Communications Manager” section on page 5-26 for details.
Understanding the Cisco Unified IP Phones 7906G
and 7911G Components
The Cisco Unified IP Phones 7906G and 7911G include these components on the
phone or as accessories for the phone:
• Network and Access Ports, page 3-4
• Handset, page 3-4
• Speaker, page 3-4
• Headset, page 3-6
To Next Page
Loading...
Need help?
General