Cisco 7911G - IP Phone VoIP

2-19
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Determining the MAC Address of a Cisco Unified IP Phone
Deploying a Phone in an SCCP and SIP Environment
To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP
and in which the Cisco Unified Communications Manager Auto-Registration
parameter is SCCP, perform these general steps:
1. Set the Cisco Unified Communications Manager auto_registration_protocol
parameter to SCCP.
To do so, from Cisco Unified Communications Manager Administration,
choose System > Enterprise Parameters.
2. Install the phones.
3. Change the auto_registration_protocol parameter to SIP.
4. Auto-register the SIP phones.
Determining the MAC Address of a
Cisco Unified IP Phone
Several of the procedures that are described in this manual require you to
determine the MAC address of a Cisco Unified IP Phone. You can determine the
MAC address for a phone in any of these ways:
• From the phone, press the Applications Menu button, then choose
Settings > Network Configuration, and look at the MAC Address field.
• Look at the MAC label on the back of the phone.
• Display the web page for the phone and click the Device Information
hyperlink.
For information about accessing the web page, see the “Accessing the Web
Page for a Phone” section on page 8-2.