8-15
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Chapter 8 Monitoring the Cisco Unified IP Phone Remotely
Streaming Statistics
Streaming Statistics
A Cisco Unified IP Phone can stream information to and from up to three devices
simultaneously. A phone streams information when it is on a a call or running a
service that sends or receives audio or data.
The streaming statistics areas on a phone web page provide information about the
streams. Most calls use only one stream (Stream 1), but some calls use two or
three stream. For example, a barged call uses Stream 1 and Stream 2.
To display a Streaming Statistics area, access the web page for the phone as
described in the “Accessing the Web Page for a Phone” section on page 8-2, and
then click the Stream 1, the Stream 2, or the Stream 3 hyperlink.
Table 8-5 describes the items in the Streaming Statistics areas.
Table 8-5 Streaming Statistics Area Items
Item Description
Remote Address IP address and UDP port of the destination of the stream.
Local Address IP address and UPD port of the phone.
Start Time Internal time stamp indicating when Cisco Unified Communications
Manager requested that the phone start transmitting packets.
Stream Status Indication of whether streaming is active.
Host Name Unique, fixed name that is automatically assigned to the phone based on its
MAC address.
Sender Packets Total number of RTP data packets transmitted by the phone since starting this
connection. The value is 0 if the connection is set to receive only mode.
Sender Octets Total number of payload octets transmitted in RTP data packets by the phone
since starting this connection. The value is 0 if the connection is set to receive
only mode.
Sender Codec Type of audio encoding used for the transmitted stream.
Sender Reports Sent
1
Number of times the RTCP Sender Reports have been sent.
Sender Report Time
Sent
1
Internal time stamp indication when a RTCP Sender Report was sent.
To Next Page
Loading...
Need help?
General