Cisco 7911G - IP Phone VoIP User Manual

7-5
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified Communications Manager 6.0
OL11954-01
Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Status Menu
Step 4 Select Status Messages.
To remove current status messages, press the Clear softkey.
To exit the Status Messages screen, press the Exit softkey.
Table 7-3 Status Messages on the Cisco Unified IP Phones 7906G and 7911G
Message Description Possible Explanation and Action
BootP server used The phone obtained its IP
address from a BootP server
rather than from a DHCP
server.
None. This message is informational only.
CFG file not found The name-based and default
configuration file was not
found on the TFTP Server.
The configuration file for a phone is created
when the phone is added to the Cisco Unified
Communications Manager database. If the
phone has not been added to the Cisco Unified
Communications Manager database, the
TFTP server generates a
CFG File Not Found
response.
• Phone is not registered with Cisco
Unified Communications Manager.
You must manually add the phone to
Cisco Unified Communications Manager
if you are not allowing phones to
auto-register. See the ““Adding Phones
with Cisco Unified Communications
Manager Administration” section on
page 2-16 for details.
• If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
• If you are using static IP addresses, check
configuration of the TFTP server. See the
“Network Configuration Menu” section
on page 4-7for details about assigning a
TFTP server.

Cisco 7911G - IP Phone VoIP Specifications

General

Brand	Cisco
Model	7911G - IP Phone VoIP
Category	IP Phone
Language	English