Cisco 7941G

Configuration referenceDescriptionFeature
For more information, see Cisco Unified
Communications Manager Features and
Services Guide, “Do Not Disturb” chapter.
When DND is turned on, either no audible rings occur
during the ringing-in state of a call, or no audible or visual
notifications of any type occur.
You can configure the phone to have a softkey template
with a DND softkey or a phone-button template with DND
as one of the selected features.
The following DND-related parameters are configurable
in Cisco Unified Communications Manager
Administration:
•
Do Not Disturb: This check box allows you to enable
DND on a per-phone basis. From Cisco Unified
Communications Manager Administration, choose
Device > Phone > Phone Configuration.
• DND Option: Choose “Call Reject” (to turn off all
audible and visual notifications), or “Ringer Off” (to
turn off only the ringer). DND Option appears on
both the Common Phone Profile window and the
Phone Configuration window (Phone Configuration
window value takes precedence).
•
DND Incoming Call Alert: Choose the type of alert
to play, if any, on a phone for incoming calls when
DND is active. This parameter is located on both the
Common Phone Profile page and the Phone
configuration page (Phone Configuration window
value takes precedence).
•
BLF Status Depicts DND: Enables DND status to
override busy/idle state.
Do Not Disturb (DND)
1
To disable enbloc dialing, in Cisco
Unified Communications Manager
Administration, go to Device > Phone.
2
On the Phone Configuration window,
in the “Product Specific Configuration
Layout” area, uncheck the “Enbloc
Dialing” check box, then click Apply
Config, and click Save.
Enbloc dialing enables SCCP to send all digits of a phone
number simultaneously. This feature must be disabled if
either Forced Authorization Codes (FAC) or Client Matter
Codes (CMC) dialing is being used.
Enbloc Dialing
(SCCP phones only)
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
130
Features, Templates, Services, and Users
Telephony Features Available for Cisco Unified IP Phone