Cisco 7941G

Configuration referenceDescriptionFeature
For more information about configuring
this feature, see Cisco Unified
Communications Manager Features and
Services Guide, “Hold Reversion” chapter.
Limits the amount of time that a call can be on hold before
reverting back to the phone that put the call on hold and
alerting the user.
Reverting calls are distinguished from incoming calls by
a single ring (or beep, depending on the new call indicator
setting for the line). This notification repeats at intervals
as long as the call is not resumed.
A call that triggers Hold Reversion also displays an
animated icon in the call bubble and a brief message on
the status line.
You can configure call focus priority to favor incoming or
reverting calls.
Hold Reversion
No configuration required.Enables phones with a shared line to distinguish between
the local and remote lines that placed a call on hold.
Hold Status
For more information, see:
•
Cisco Unified Communications
Manager Administration Guide, “Hunt
List Configuration” chapter
•
Cisco Unified Communications
Manager System Guide,
“Understanding Route Plan” chapter
•
Cisco Unified Communications
Manager Administration Guide, “CTI
Route Point Configuration” chapter
Provides load sharing for calls to a main directory number.
A hunt group contains a series of directory numbers that
can answer the incoming calls.
When an incoming call is offered to a directory number
that is part of the hunt group, this feature displays the main
directory number in addition to the calling party.
Hunt Group Display
For more information, see Cisco
Unified Communications Manager Features
and Services Guide, “Immediate Divert”
chapter.
Allows a user to transfer a ringing, connected, or held call
directly to a voice-messaging system. When a call is
diverted, the line becomes available to make or receive
new calls.
Immediate Divert
For more information, see Cisco Unified
Communications Manager System Guide,
“Cisco Unified IP Phones” chapter.
Allows users to transfer incoming calls directly to their
voice messaging system or to the voice messaging system
of the original called party.
Immediate
Divert—Enhanced
For more information, see Cisco Unified
Communications Manager Features and
Services Guide, “Cisco Unified Mobility”
chapter.
Reroutes a direct call to a user’s mobile phone to the
enterprise number (desk phone). For an incoming call to
a remote destination (mobile phone), only the remote
destination rings; the desk phone does not ring. When the
call is answered on the mobile phone, the desk phone
displays a Remote in Use message. During these calls, a
user can use the various features of the mobile phone.
Intelligent Session Control
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
132
Features, Templates, Services, and Users
Telephony Features Available for Cisco Unified IP Phone