Cisco 7941G

Configuration referenceDescriptionFeature
For more information, see Cisco Unified
Communications Manager Feature and
Services Guide, “Intercom” chapter.
Allows users to place and receive intercom calls using
programmable phone buttons. You can configure intercom
line buttons to:
•
Directly dial a specific intercom extension.
•
Initiate an intercom call and then prompt the user to
enter a valid intercom number.
If your user logs into the same phone on a daily
basis using their Cisco Extension Mobility profile,
assign the phone button template that contains
intercom information to their profile, and assign
the phone as the default intercom device for the
intercom line.
Note
Intercom
For more information, see:
•
Softkey Templates, on page 148.
•
Cisco Unified Communications
Manager System Guide, “Cisco
Unified IP Phone” chapter
Allows a user to join two or more calls that are on one line
to create a conference call and remain on the call.
Join/Select
For more information, see:
•
Softkey Templates, on page 148.
•
Cisco Unified Communications
Manager System Guide, “Cisco
Unified IP Phones” chapter.
Allows users to apply the Join feature to calls that are on
multiple phone lines.
Join Across Lines/Select
For more information, see the option
“Always use prime line” in the following
chapters of Cisco Unified Communications
Manager Administration Guide:
• “Device Profile Configuration”
• “Common Phone Profile
Configuration”
• “Cisco Unified IP Phone
Configuration”
If this feature is disabled (default), then the ringing line is
selected. When enabled, the primary line is picked up even
if a call is ringing on another line. The user must manually
select the other line.
This feature can also be enabled or disabled for
Extension Mobility.
Note
Line select
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
133
Features, Templates, Services, and Users
Telephony Features Available for Cisco Unified IP Phone