Cisco 7941G Administration Guide

Possible Explanation and ActionDescriptionMessage
•
The file is corrupted. If the file is a phone
configuration file, delete the phone from the
Cisco Unified Communications Manager
database using Cisco Unified Communications
Manager Administration. Then add the phone
back to the Cisco Unified Communications
Manager database using Cisco Unified
Communications Manager Administration.
•
There is a problem with the CTL file and the
key for the server from which files are obtained
is bad. In this case, run the CTL client and
update the CTL file, making sure that the proper
TFTP servers are included in this file.
An error occurred when the phone tried to
validate the signature of a signed file. This
message includes the name of the file that
failed.
File auth error
From Cisco Unified Operating System
Administration, make sure that the phone load file is
on the TFTP server, and that the entry in the
configuration file is correct.
The phone cannot locate, on the TFTP
server, the phone load file that is specified
in the phone configuration file.
File not found
The phone remains idle until it is power cycled or
you reset the DHCP address. See Network
Configuration Menu, on page 64 for details.
The phone has been configured to release
its IP address.
IP address released
None. This message is informational only. The ITL
file was not installed previously.
For more information about the ITL file, see Cisco
Unified Communications Manager Security Guide.
The ITL file is installed in the phone.ITL installed
Check that:
•
A good version of the configuration file exists
on the applicable server.
•
The phone load file being downloaded has not
been altered or renamed.
•
The phone load type is compatible; for example,
you cannot place a DEV load configuration file
on a REL-signed phone.
The phone could not load a configuration
file.
Load Auth Failed
Check the load ID assigned to the phone (from Cisco
Unified Communications Manager, choose Device >
Phone). Verify that the load ID is entered correctly.
Load ID of the software file is of the wrong
type.
Load ID incorrect
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
175
Model Information, Status, and Statistics
Status Messages Screen

Cisco 7941G Specifications

General

Keypad number of keys	12
Touchscreen	-
Display resolution	320 x 222 pixels
Speakerphone	Yes
Voice codecs	G.729a
Bluetooth	No
Supported network protocols	DHCP, TFTP, SCCP, DSCP
Ethernet LAN (RJ-45) ports	2
Input voltage	48 V
Dimensions (WxDxH)	266.7 x 152.4 x 203.2 mm
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Safety	(UL) 60950, (CSA) C22.2 No. 60950, IEC 60950, EN 60950, AS/NZS 60950
Certification	CE (FCC) 15 (CFR 47) B ICES-003 B EN55022 B CISPR22 B AS/NZ 3548 B VCCI B EN55024 EN 50082-1 EN 61000-3-2 EN 61000-3-3
Compliance industry standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1Q, IEEE 802.3af
Lines quantity	- lines
Phonebook capacity	- entries
Number of handles included	1 pc(s)

Weight and Dimensions

Weight	1600 g