Cisco 7961G-GE - IP Phone VoIP

4-25
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
OL-11953-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
NTP Configuration Menu
The NTP Configuration menu, which opens when you select NTP Configuration
on the Locale Configuration menu, displays information about the NTP server and
mode configuration used by the phone. Table 4-8 describes the options on this
menu. For more information, see Locale Configuration Menu, page 4-24.
Table 4-8 NTP Configuration Menu Options
Option Description To Change
NTP Server 1 IP address of the primary NTP server. Use Cisco Unified Communications
Manager Administration to modify.
NTP Server 2 IP address of the secondary or backup
NTP server.
Use Cisco Unified Communications
Manager Administration to modify.
NTP Mode 1 Primary server mode. Supported modes
are Directed Broadcast and Unicast.
Use Cisco Unified Communications
Manager Administration to modify.
NTP Mode 2 Secondary server mode. Supported
modes are Directed Broadcast and
Unicast.
Display only—cannot configure.