Cisco 7961G-GE - IP Phone VoIP User Manual

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Determining the MAC Address for a Cisco Unified IP Phone
2-20
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
OL-11953-01
Deploying a Phone in an SCCP and SIP Environment
To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP
and in which the Cisco Unified Communications Manager Auto-Registration
parameter is SCCP, perform these general steps:
1. Set the Cisco Unified Communications Manager auto_registration_protocol
parameter to SCCP.
To do so, from Cisco Unified Communications Manager Administration,
choose System > Enterprise Parameters.
2. Install the phones.
3. Change the auto_registration_protocol parameter to SIP.
4. Auto-register the SIP phones.
Determining the MAC Address for a Cisco Unified IP
Phone
Several procedures described in this manual require you to determine the MAC
address of a Cisco Unified IP Phone. You can determine a phone’s MAC address
in these ways:
• From the phone, press the Settings button and select Model Information and
look at the MAC Address field.
• Look at the MAC label on the back of the phone.
• Display the web page for the phone and click the Device Information
hyperlink.
For information about accessing the web page, see the “Accessing the Web
Page for a Phone” section on page 8-2.

Cisco 7961G-GE - IP Phone VoIP Specifications

General

Brand	Cisco
Model	7961G-GE - IP Phone VoIP
Category	IP Phone
Language	English