4-17
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
OL-11953-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
• Encrypted icon—Appears as a padlock and indicates that the
connection to the Cisco Unified Communications Manager is authenticated
and encrypted. For more information about authentication and encryption,
refer to Cisco Unified Communications Manager Security Guide.
SIP Configuration Menu (SIP Phones Only)
The SIP Configuration menu contains these sub-menus:
• SIP General Configuration Menu, page 4-17
• Line Settings Menu, page 4-20
SIP General Configuration Menu
The SIP General Configuration menu displays information about the configurable
SIP parameters on the phone. Table 4-3 describes the options in this menu.
Table 4-3 SIP General Configuration Menu Options
Option Description To Change
Preferred CODEC Displays the CODEC to use when a call is
initiated. This value will always be set to
none.
Display only—cannot configure.
Out of Band DTMF Displays the configuration of the
out-of-band signaling (for tone detection
on the IP side of a gateway). The Cisco
Unified SIP IP phone supports out-of-band
signaling using the AVT tone method. This
value will always be set to avt.
Display only—cannot configure.
Register with Proxy Displays if the phone must register with a
proxy server during initialization. This
value will always be set to true.
Display only—cannot configure.
Register Expires Displays the amount of time, in seconds,
after which a registration request expires.
From Cisco Unified
Communications Manager,
choose Administration
>Device>
Device Settings > SIP Profile.
To Next Page
Loading...
