Cisco 7961G-GE - IP Phone VoIP

3-11
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
OL-11953-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Attaching the Cisco Unified IP Phone Expansion Module 7914 (SCCP Phones Only)
Related Topics
• Adjusting the Placement of the Cisco Unified IP Phone, page 3-13
• Verifying the Phone Startup Process, page 3-16
• Configuring Startup Network Settings, page 3-18
• Configuring Security on the Cisco Unified IP Phone, page 3-18
Attaching the Cisco Unified IP Phone Expansion
Module 7914 (SCCP Phones Only)
The Cisco Unified IP Phone Expansion Module 7914 attaches to a Cisco Unified
IP Phone 7961G and 7961G-GE to extend the number or line appearances or
programmable buttons on your phone. You can customize the button templates for
the Cisco Unified IP Phone Expansion Module 7914 to determine the number of
line appearances and speed dial buttons. See the “Modifying Phone Button
Templates” section on page 5-27 for details.
You can attach a Cisco Unified IP Phone Expansion Module 7914 to the
Cisco Unified IP Phone 7961G and 7961G-GE:
• When you initially add the phone to Cisco Unified Communications Manager
by selecting 7914 14-Button Line Expansion Module in the Module 1 or
Module 2 fields and selecting the appropriate expansion module firmware.
See Step 6 in the following procedure.
• After the phone is configured in Cisco Unified Communications Manager.
To configure the Cisco Unified IP Phone Expansion Module 7914 on the
Cisco Unified IP Phone, follow these steps:
Procedure
Step 1 Log in to the Cisco Unified Communications Manager Administration
application.
The Cisco Unified Communications Manager Administration page appears.
Step 2 From the menu, choose Device > Phone.