Cisco 7961G-GE - IP Phone VoIP

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
4-36
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
OL-11953-01
Ethernet Configuration Menu
The Ethernet Configuration menu includes the options that are described in
Table 4-11.
Table 4-11 Ethernet Configuration Menu Option
Option Description To Change
Forwarding
Delay
Indicates whether the internal switch
begins forwarding packets between the
PC port and switched port on the phone
when the phone becomes active.
• When forwarding delay is set to
disabled, the internal switch begins
forwarding packets immediately.
• When forwarding delay is set to
enabled, the internal switch waits 8
seconds before forwarding packets
between the PC port and the switch
port.
Default is disabled.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
Span to PC Port Indicates whether the phone will
forward packets transmitted and
received on the network port to the
access port.
Enable this option if an application that
requires monitoring of the phone’s
traffic is being run on the access port.
These applications include monitoring
and recording applications (common in
call center environments) and network
packet capture tools that are used for
diagnostic purposes.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.