Cisco IP Phone 8800 Series Wireless LAN Deployment Guide
that logging does not display to the console, nor to the connected downstream
port. PC Controlled indicates that the workstation attached to the PC port will
control whether logging is enabled. Enabled indicates that logs are always sent
both to the console and to downstream port. Use Enabled to force logs on so they
can be captured with a packet sniffer.
This can be used to configure whether the recording tone is enabled or disabled
on the phone. If enabled, the phone mixes the recording tone into both directions
for every call.
Recording Tone Local Volume
This can be used to configure the loudness setting of the recording tone that the
local party hears. This loudness setting applies regardless of the actual device
used for hearing (handset, speakerphone, headset). The loudness setting should be
in the range of 0% to 100%, with 0% being no tone and 100% being at the same
level as the current volume setting. The default value is 100%.
Recording Tone Remote Volume
This can be used to configure the loudness setting of the recording tone that the
remote party hears. The loudness setting should be in the range of 0% to 100%,
with 0% being less than -66dBM and 100% being -4dBM. The default value is -
10dBM or 50%.
Indicates the length of time in milliseconds for which the recording tone is
inserted in the audio stream. The default for this parameter is set to the value in
the Network locale file for this field. The valid range for this parameter is a value
between 1 and 3000 milliseconds.
Specifies an IP address and port of a remote system where log messages are sent.
The format is:xxx.xxx.xxx.xxx:ppppp@@options. Options will be format as
base=x;pfs=y; base value range is 0~7,pfs value range is 0~1.And the two
parameters are optional. Absence of pfs or base,pfs will be set to the default value
0 and base will be set to the default value 7.
Cisco Discover Protocol (CDP):
Switch Port
Allows administrator to enable or disable Cisco Discovery Protocol (CDP) on the
switch port.
Cisco Discover Protocol (CDP): PC
Port
Allows administrator to enable or disable Cisco Discovery Protocol (CDP) on the
PC port.
Link Layer Discovery Protocol -
Media Endpoint Discover (LLDP-
MED): Switch Port
Allows administrator to enable or disable Link Layer Discovery Protocol (LLDP-
MED) on the switch port.
Link Layer Discovery Protocol –
(LLDP): PC Port
Allows administrator to enable or disable Link Layer Discovery Protocol (LLDP)
on the PC port.
Allows administrator to set Asset ID for Link Layer Discovery Protocol.
Allows administrator to set Power Priority for Link Layer Discovery Protocol.
Specifies the 802.1x authentication feature status
Automatic Port Synchronization
Enables the phone to synchronize the PC and SW ports to the same speed and to
duplex. Only ports configured for auto negotiate change speeds.
Switch Port Remote Configuration
Allows remote configuration of the speed and duplex for the switch port of the
phone, which overrides any manual configuration at the phone. Be aware that
configuring this port may cause the phone to lose network connectivity.
PC Port Remote Configuration
Allows remote configuration of the speed and duplex for the PC port of the
To Next Page
Loading...
Need help?
General
