Cisco 8831 Administration Guide

Set Admin VLAN ID
Procedure
Step 1
Choose Apps > Admin Settings > Network Configuration > Admin VLAN ID.
Enter your password at the prompt.
Step 2
Enter a new Admin VLAN ID.
Step 3
Press Apply, and then Save.
IPv4 Setup menu options
The IPv4 Setup menu is a submenu of the Network Setup menu. To reach the IPv4 Setup menu, select the
IPv4 option on the Network Setup menu.
The following table describes the IPv4 Setup menu options.
For information about the keys you can use to edit options, see Value input and editing guidelines, on page
61.
Table 19: IPv4 Setup menu options
To ChangeDescriptionOption
Set DHCP, on page 65Indicates whether the conference phone has
DHCP enabled or disabled.
When DHCP is enabled, the DHCP server
assigns the conference phone an IP address.
When DHCP is disabled, the administrator
must manually assign an IP address to
the phone.
For more information, see DHCP usage.
DHCP
Set IP address, on page 66Internet Protocol (IP) address of the
conference phone.
If you assign an IP address with this option,
you must also assign a subnet mask and
default router. See the Subnet Mask and
Default Router options in this table.
IP Address
Set subnet mask, on page 66Subnet mask used by the phone.Subnet Mask
Set default router, on page 67Default router used by the phone (Default
Router 1).
Default Router 1
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager
9.0
64
Cisco Unified IP Conference Phone 8831 settings
Set Admin VLAN ID

Cisco 8831 Specifications

General

Headset Port	No dedicated headset port
Wireless	No
Bluetooth	No
USB Port	No
Video Support	No
Audio	Full-duplex speakerphone
Connectivity	10/100 Ethernet
Power	Power over Ethernet (PoE)
Network Protocols	SIP
Weight	1.1 kg
Audio Codecs	G.711, G.722, G.729, iLBC
Network Ports	2 x Ethernet ports
Security	TLS