Cisco 8831 - Divert; Divert call; Do Not Disturb; Turn DND on and off

CHAPTER 4
Cisco Unified IP Conference Phone 8831
installation
This chapter helps you set up and install the Cisco Unified IP Conference Phone 8831 on an IP telephony
network.
Before you install a conference phone, you must decide how to configure the conference phone in your
network. After you have determined your configuration requirements, you can install the conference phone
and verify its functionality. For more information, see Cisco Unified IP Phones and telephony networks,
on page 35
Note
This chapter includes the following topics:
•
Before you begin, page 45
•
Cisco Unified IP Conference Phone 8831 components, page 47
•
Cisco Unified IP Conference Phone 8831 setup, page 50
•
IP Phone startup verification, page 55
•
Network settings, page 55
•
Cisco Unified IP Phone security, page 56
Before you begin
Before you install the conference phone, review the requirements in the following sections.
Network requirements
For the Cisco Unified IP Conference Station to successfully operate as an endpoint in your network, your
network must meet these requirements:
•
VoIP network:
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager 9.0
45