CHAPTER 6
Features, templates, services, and user setup
After you install conferences stations in your network, configure network settings, and add each Cisco Unified
IP Conference Phone 8831 to Cisco Unified Communications Manager, you must use the Cisco Unified
Communications Manager Administration application to configure telephony features, optionally modify
conference phone templates, set up services, and assign users.
This chapter provides an overview of these configuration and setup procedures. Cisco Unified Communications
Manager documentation provides detailed instructions for these procedures.
For suggestions about how to provide users with information about features, and what information to provide,
see Internal support website, on page 141.
For information about setting up conference phones in non-English environments, see International user
support, on page 145.
This chapter includes the following topics:
•
Available telephony features, page 76
•
Corporate and Personal Directory setup, page 90
•
Button templates, page 91
•
Softkey templates, page 92
•
Enable Device Invoked Recording, page 94
•
Enable Call History for shared line, page 95
•
Services setup, page 95
•
Cisco Unified Communications Manager user addition, page 96
•
User Options web page management, page 97
•
Call Waiting setup, page 98
•
Call Forward Notification setup, page 98
•
Calling party normalization, page 99
•
Incoming Call Notification Window timer setup, page 99
•
Linked Mode, page 100
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager 9.0
75
To Next Page
Loading...
