Procedure
Step 1
Press Apps and choose Admin Settings > Network Setup > Ethernet Setup > IPv4 Setup.
Step 2
To enable DHCP, set DHCP Enabled to Yes. DHCP is enabled by default.
Step 3
To use an alternate TFTP server, set Alternate TFTP Server to Yes, and enter the IP address for the TFTP
Server.
Consult with the network administrator to determine whether you need to assign an alternative TFTP
server instead of using the TFTP server that DHCP assigns.
Note
Step 4
Press Apply, and then press Save.
Set up IP Phone to not use DHCP
When not using DHCP, you must configure the IP address, subnet mask, TFTP server, and default router
locally on the conference station.
Procedure
Step 1
Press Apps and choose Admin Settings > Network Setup > Ethernet Setup > IPv4 Setup.
Step 2
To disable DHCP and manually set an IP address:
a) Set DHCP Enabled to No.
b) Enter the static IP address for the conference station.
c) Enter the subnet mask.
d) Enter the default router IP addresses.
e) Set Alternate TFTP Server to Yes, and enter the IP address for TFTP Server 1.
Step 3
Press Apply, and then press Save.
Related Topics
Set DHCP, on page 65
Set subnet mask, on page 66
Set IP address, on page 66
Set default router, on page 67
Set Alternate TFTP, on page 68
Set TFTP Server 1, on page 68
Security Configuration menu
The Security Configuration menu provides information about various security settings. It provides access to
the Trust List File screen and the 802.1x authentication.
Access the Security Configuration menu from Apps > Admin Settings > Security Setup
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager
9.0
70
Cisco Unified IP Conference Phone 8831 settings
Security Configuration menu
To Next Page
Loading...
Need help?
General
