Parameters for Reporting the Phone Configuration to the Server
Table 6: Parameters for Reporting the Phone Configuration to the Server
DescriptionField
Specifies how the phone reports its current internal configuration to the provisioning server.
The URLs in this field specify the destination for a report and can include an encryption
key.
You can use the following keywords, encryption key, and file locations and names to
control how you store the phone configuration information:
• No keywords and only an XML file reports the entire configuration data to server.
• [--status] keyword reports the status data to server.
• [--delta] keyword reports the changed configuration to server.
• [--key <encryption key>] keyword tells the phone to apply AES-256-CBC
encryption with the specified encryption key to the configuration report, before sending
it to the server.
You can enclose the encryption key in double-quotes (") optionally.
If you have provisioned the phone with Input Keying Material (IKM) and
want the phone to apply RFC 8188-based encryption to the file, do not
specify a AES-256-CBC encryption key.
Note
• Two rules used together as:
[--delta]http://my_http_server/config-mpp-delta.xml
[--status]http://my_http_server/config-mpp-status.xml
If you need to use the [--delta]xml-delta file rule and the [--status]xml-status
file rule together, you must separate the two rules with a space.
Caution
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<Profile_Rule ua="na">
[--delta]http://my_http_server/config-mpp-delta.xml
[--status]http://my_http_server/config-mpp-status.xml
</Profile_Rule>
• In the phone web interface, enter the profile rule in this field.
Report Rule
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
113
Cisco IP Phone Configuration
Parameters for Reporting the Phone Configuration to the Server
To Next Page
Loading...
Need help?
General
