Cisco 8851 Guide

CHAPTER 5
Provisioning Parameters
• Provisioning Parameters Overview, on page 67
• Configuration Profile Parameters, on page 67
• Firmware Upgrade Parameters, on page 72
• General Purpose Parameters, on page 73
• Macro Expansion Variables, on page 73
• Internal Error Codes, on page 76
Provisioning Parameters Overview
This chapter describes the provisioning parameters that can be used in configuration profile scripts.
Configuration Profile Parameters
The following table defines the function and usage of each parameter in the Configuration Profile Parameters
section under the Provisioning tab.
Description and Default ValueParameter Name
Controls all resync actions independently of firmware
upgrade actions. Set to Yes to enable remote
provisioning.
The default value is Yes.
Provision Enable
Triggers a resync after every reboot except for reboots
caused by parameter updates and firmware upgrades.
The default value is Yes.
Resync On Reset
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
67

Cisco 8851 Specifications

General

Resolution	800 x 480 pixels
Network Interfaces	Dual Gigabit Ethernet ports
Headset Port	Yes
Audio	Wideband audio
Ethernet	10/100/1000 Mbps
USB	Yes, USB 2.0
Power	IEEE 802.3af/at Power over Ethernet (PoE)
Protocols	SIP
PoE	Yes
Codec Support	G.711, G.722, G.729, iLBC
Headset Connector	RJ9
Lines	Up to 5 lines
Dimensions	229 x 256 x 41 mm (excluding foot stand)
Weight	1.2 kg