Configure the Subscriber Information Parameters
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > Ext(n), where n is an extension number.
Step 2 In the Subscriber Information section, set the parameter values as described in the Subscriber Information
Parameters, on page 382 table.
Step 3 Click Submit All Changes.
Subscriber Information Parameters
The following table defines the function and usage of the parameters in the RTP Parameters section under the
SIP tab in the phone web interface. It also defines the syntax of the string that is added in the phone
configuration file with XML(cfg.xml) code to configure a parameter.
Table 77: Subscriber Information
DescriptionParameter
Name displayed as the caller ID.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Display_Name_1_ ua="na"/>
• In the phone web page, enter a name that
represents the caller ID.
Display Name
Extension number for this line.
When you need to refer to this user ID in another
setting, for example, the short name for a line key,
use the $USER macro variable.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<User_ID_1_ ua="na">7001</User_ID_1_>
• In the phone web page, enter an extension
number
User ID
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
382
Cisco IP Phone Installation
Configure the Subscriber Information Parameters
To Next Page
Loading...
Need help?
General
