EasyManuals Logo

Cisco 8851 Guide

Cisco 8851
544 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #498 background imageLoading...
Page #498 background image
• The fast-charging feature on the back USB does not work when more than one key expansion module
is attached to a Cisco IP Phone 8861 and 8865 using 802.3at PoE.
• The fast-charging feature on the back USB doesn’t work when more than one key expansion module is
attached to a Cisco IP Phone 8861 and 8865, unless Cisco Universal PoE (UPoE) is used.
• Cisco IP Phone 8851 with 2 key expansion modules works on 802.3at PoE only with v08 or later hardware.
You can find the phone version information on the lower back of the phone as part of the TAN and PID
label. Version information is also located on the individual phone packaging.
Note
Connect a Key Expansion Module to a Cisco IP Phone
If you want to install more than one key expansion module, you repeat steps 7-9 to connect the other key
expansion modules together.
Procedure
Step 1 Unplug the Ethernet cable from the phone.
Step 2 If installed, remove the footstand from the phone.
Step 3 Locate the accessory connector covers on the side of the phone.
This diagram shows the location.
Step 4 Remove the two accessory connector covers, as shown in the diagram.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
478
Cisco IP Phone Accessories
Connect a Key Expansion Module to a Cisco IP Phone

Table of Contents

Other manuals for Cisco 8851

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 8851 and is the answer not in the manual?

Cisco 8851 Specifications

General IconGeneral
Resolution800 x 480 pixels
Network InterfacesDual Gigabit Ethernet ports
Headset PortYes
AudioWideband audio
Ethernet10/100/1000 Mbps
USBYes, USB 2.0
PowerIEEE 802.3af/at Power over Ethernet (PoE)
ProtocolsSIP
PoEYes
Codec SupportG.711, G.722, G.729, iLBC
Headset ConnectorRJ9
LinesUp to 5 lines
Dimensions229 x 256 x 41 mm (excluding foot stand)
Weight1.2 kg

Related product manuals