Cisco ASR 1000 Series Installation And Configuration Guide

4-30
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
Chapter 4 Cisco ASR 1006 Router Overview and Installation
Auxiliary Connection
Auxiliary Connection
This asynchronous EIA/TIA-232 serial port (AUX) is used to connect a modem to the Cisco ASR 1000
Series Route Processor 1 for remote administrative access. Use the following procedure to connect the
Cisco
ASR 1006 Router to a modem.
Step 1 Connect one end of the modem cable to the RJ-45 port on the primary Cisco ASR 1000 Series Route
Processor 1, labeled AUX.
Figure 4-21 Cisco ASR 1000 Series RP1 Port Connectors and LEDs
Step 2 Run the cable up and through the cable-management bracket U feature device as shown in Figure 4-20
and connect the other end of the cable to your modem.
If you have completed all cable connections, go to, Chapter 7, “Cisco ASR 1000 Series Routers Power
Up and Initial Configuration.”
1 AUX port 4 LINK LED
2 CON port 5 BITS port
3 MGMT Ethernet port 6 CARRIER LED
CARRIER
LINK
MGMT ETHERNET BITS CON AUX
280079
1 2 3 4 5 6

Cisco ASR 1000 Series Specifications

General

Series	ASR 1000
Category	Network Router
Operating System	Cisco IOS XE
Memory	Up to 64 GB
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC options
Dimensions	Varies by model
Encryption	IPsec, SSL
Storage	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model