CHAPTER
6-1
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
6
Cisco ASR 1002 Router Overview and Installation
This chapter describes the Cisco ASR 1002 Router and provides procedures for installing the
Cisco
ASR 1002 Router on an equipment shelf or tabletop or in an equipment rack.
This chapter contains the following sections:
• Cisco ASR 1002 Router Description, page 6-1
• General Rack Installation Guidelines, page 6-10
• Guidelines for an Equipment Shelf or Tabletop Installation, page 6-11
• Equipment Shelf or Tabletop Installation, page 6-12
• Rack-Mounting a Cisco ASR 1002 Router, page 6-13
• Two-Post Rack Installation, page 6-18
• Attaching a Chassis Ground Connection, page 6-23
• Connecting Power to Cisco ASR 1002 Router, page 6-27
Cisco ASR 1002 Router Description
The Cisco ASR 1002 Router is part of the Cisco aggregation services family of routers. The Cisco
ASR
1002 Router offers a compact form factor router that satisfies customer demands such as low power
consumption and decreased usage of rack space.
The Cisco ASR 1002 Router supports three half-height SPAs and an optional built-in 4xGE SPA. The
Cisco ASR 1002 Router supports all the general-purpose routing and security features of the Cisco ASR
1000 Series Routers. It uses the same internal control and data-plane architecture as the other Cisco
ASR
1000 Series Routers.
The Cisco ASR 1002 Router supports:
• Cisco ASR1000-ESP5 or Cisco ASR1000-ESP10 as a field-replaceable unit (FRU)
• The Cisco Embedded Route Processor which supports 2MB upgradeable BootROM and 8GB eUSB
bulk storage.
• 1 + 1 redundant AC or DC power supplies.
• Stratum-3 network clocking per GR-1244-CORE, with T1/E1 BITS interface or SPAs as timing
sources.
To Next Page
Loading...
Need help?
General
