Cisco ASR 1000 Series Installation And Configuration Guide

Glossary
GL-5
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
J
K
L
LC
Line card
LDP
Label Distribution Protocol
LIPC
Local IPC between two processes
Location ID
A location ID is configured on each data border element (DBE). The signaling border element (SBE)
may associate endpoints with a particular location ID and then use the location IDs to route calls
between different DBEs.
M
Media address
Pool of IP addresses on the DBE for media relay functionality. A pool of addresses is defined for the
Global VPN that the DBE is attached to. All vDBEs within the DBE draw media addresses from this
pool.
MGCP
Media Gateway Control Protocol. This is a VoIP signaling protocol, usually used between a dumb
device and a clever controller. It is similar in functionality (if not syntax) to H.248. It is defined in RFC
2705.
MPLS
Multi-Protocol Label Switching
N
NAT
Network Address Translation. This is a program or piece of hardware that converts an IP address from
a private address to a public address in real time. It allows multiple users to share a single public IP
address.
NAT traversal
Detects that the endpoints are behind a NAT device.
NBAR
Network-based Application Recognition

Cisco ASR 1000 Series Specifications

General

Series	ASR 1000
Category	Network Router
Operating System	Cisco IOS XE
Memory	Up to 64 GB
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC options
Dimensions	Varies by model
Encryption	IPsec, SSL
Storage	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model