Cisco ASR 9000 Serie

PurposeCommand or Action
Example:
RP/0/RSP0/CPU0:router(config-ipsla-sched)# start-time
01:00:00
•
(Optional) Use the pending keyword to configure
the operation to remain in a pending (unstarted)
state. The default value is inactive. If the
start-time command is not specified, no
information is collected until the start time is
configured or a trigger occurs that performs an
immediate start.
•
(Optional) Use the now keyword to indicate that
the operation should start immediately.
•
(Optional) Use the after keyword and associated
arguments to specify the time after which the
operation starts collecting information.
commit
Step 14
Displays the current statistics.
show ipsla statistics [operation-number]
Example:
RP/0/RSP0/CPU0:router# show ipsla statistics 432
Step 15
Configuring and Scheduling an ICMP Path-jitter Operation with Additional Parameters
You can enable an ICMP path-echo operation on the source device and configure some optional IP SLA
parameters.
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
242
Implementing IP Service Level Agreements
Configuring the ICMP Path-jitter Operation