Cisco ASR 9000 Serie

SpecificationTwo-Character Abbreviation
event_register_timertm
event_register_timer_subscriberts
event_register_wdsysmonwd
Embedded Event Manager Built-in Actions
EEM built-in actions can be requested from EEM handlers when the handlers run.
This table describes each EEM handler request or action.
Table 5: Embedded Event Manager Built-In Actions
DescriptionEmbedded Event Manager Built-In Action
Sends a message to the syslog. Arguments to this
action are priority and the message to be logged.
Log a message to syslog
Writes the command to the specified channel handler
to execute the command by using the cli_exec
command extension.
Execute a CLI command
Logs a message by using the action_syslog Tcl
command extension.
Generate a syslog message
Runs an EEM policy within a policy while the event
manager run command is running a policy in EXEC
mode.
Manually run an EEM policy
Publishes an application-specific event by using the
event_publish appl Tcl command extension.
Publish an application-specific event
Causes a router to be reloaded by using the EEM
action_reload command.
Reload the Cisco IOS software
Represents the sys_reqinfo_xxx family of
system-specific information commands by a policy
to gather system information.
Request system information
Sends the e-mail out using Simple Mail Transfer
Protocol (SMTP).
Send a short e-mail
Modifies a counter value.Set or modify a counter
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
48
Configuring and Managing Embedded Event Manager Policies
Embedded Event Manager Built-in Actions