PurposeCommand or Action
operation. A triggered target operation must finish its life
before it can be triggered again.
commit
Step 5
Configuring the MPLS LSP Monitoring Instance on a Source PE Router
Perform this task to configure the operation parameters for an MPLS LSP monitor (MPLSLM) instance. The
IP SLA measurement statistics are stored on the source PE router.
To configure an MPLS LSP monitor ping or trace instance, perform one of the following tasks:
Configuring an MPLS LSP Monitoring Ping Instance
Before You Begin
MPLS LSP monitoring is configured on a PE router.Note
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
265
Implementing IP Service Level Agreements
Configuring the MPLS LSP Monitoring Instance on a Source PE Router
To Next Page
Loading...
