Cisco ASR 9000 Serie

PurposeCommand or Action
(Optional) Specifies the maximum hop count for an
echo request packet to be used for MPLS LSP
operations. The default value is 255.
ttl time-to-live
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mplslm-lsp-ping)#
ttl 200
Step 18
(Optional) Creates a user-specified identifier for MPLS
LSP operations.
tag text
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mplslm-lsp-ping)#
tag mplslm-tag
Step 19
(Optional) Specifies the experimental field value to
be used in the MPLS header of MPLS LSP echo
request packets. The default value is 0.
exp exp-bits
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mplslm-lsp-ping)#
exp 7
Step 20
(Optional) Specifies the statistics collection parameters
for the operations in the MPLS LSP monitoring
instance. The default number of hours is 2.
statistics hourly [buckets hours]
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mplslm-lsp-ping)#
statistics hourly buckets 2
Step 21
commit
Step 22
What to Do Next
•
Configure the reaction conditions.
•
Schedule the MPLS LSP monitoring instance operations.
Configuring an MPLS LSP Monitoring Trace Instance
Before You Begin
MPLS LSP monitoring is configured on a PE router.Note
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
269
Implementing IP Service Level Agreements
Configuring the MPLS LSP Monitoring Instance on a Source PE Router