Cisco ASR 9000 Serie

SUMMARY STEPS
1.
configure
2.
logging correlator rule correlation-rule { type { stateful | nonstateful }}
3.
timeout [ milliseconds ]
4.
commit
5.
show logging correlator rule {all | correlation-rule1 ... correlation-rule14 } [ context context1 ... context
6 ] [ location node-id1...node-id6 ] [ rulesource { internal | user }] [ ruletype { nonstateful | stateful
}] [ summary | detail ]
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Configures a logging correlation rule.
logging correlator rule correlation-rule { type { stateful
| nonstateful }}
Step 2
•
Stateful correlations can change specifically if the
root-cause alarm is bistate.
Example:
RP/0/RSP0/CPU0:router(config)# logging correlator
rule rule_stateful
•
Nonstate correlations cannot change. All
non-root-cause alarms remain in the correlation
buffers.
Specifies the collection period duration time for the logging
correlator rule message.
timeout [ milliseconds ]
Example:
RP/0/RSP0/CPU0:router(config-corr-rule-st)#
timeout 60000
Step 3
•
Timeout begins when the first alarm message
identified by the correlation rule is logged.
commit
Step 4
(Optional) Displays defined correlation rules.
show logging correlator rule {all | correlation-rule1 ...
correlation-rule14 } [ context context1 ... context 6 ] [
Step 5
•
The output describes the configuration of each rule
name, including the message category, group, and
code information.
location node-id1...node-id6 ] [ rulesource { internal |
user }] [ ruletype { nonstateful | stateful }] [ summary
| detail ]
Example:
RP/0/RSP0/CPU0:router# show logging correlator
rule all
Configuring Logging Correlation Rule Sets
This task explains how to configure logging correlation rule sets.
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
10
Implementing and Monitoring Alarms and Alarm Log Correlation
Configuring Logging Correlation Rule Sets