Cisco ASR 9000 Serie

PurposeCommand or Action
(Optional) Specifies the time-to-live (TTL) value used in
the MPLS label of echo request packets. Valid values are
from 1 to 255.
ttl time-to-live
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mpls-lsp-trace)#
ttl 20
Step 11
Exits IP SLA MPLS LSP Trace configuration mode and
IP SLA configuration mode. Returns to global
configuration mode.
exit
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mpls-lsp-trace)#
Step 12
exit
RP/0/RSP0/CPU0:router(config-ipsla-op)# exit
RP/0/RSP0/CPU0:router(config-ipsla)# exit
RP/0/RSP0/CPU0:router(config)#
Schedules the start time of the operation. You can
configure a basic schedule.
ipsla schedule operation operation-number
Example:
RP/0/RSP0/CPU0:router(config)# ipsla schedule
Step 13
operation 432
RP/0/RSP0/CPU0:router(config-ipsla-sched)#
Specifies a time for the operation to start. The following
keywords are described:
start-time [hh:mm:ss {day | month day} | now | pending |
after hh:mm:ss]
Step 14
Example:
RP/0/RSP0/CPU0:router(config-ipsla-sched)#
start-time 01:00:00
•
(Optional) Use the pending keyword to configure
the operation to remain in a pending (unstarted)
state. The default value is inactive. If the start-time
command is not specified, no information is
collected until the start time is configured or a trigger
occurs that performs an immediate start.
•
(Optional) Use the now keyword to indicate that the
operation should start immediately.
•
(Optional) Use the after keyword and associated
arguments to specify the time after which the
operation starts collecting information.
commit
Step 15
Displays the current IP SLA statistics for the trace
operation.
show ipsla statistics [operation-number]
Example:
RP/0/RSP0/CPU0:router # show ipsla statistics 432
Step 16
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
253
Implementing IP Service Level Agreements
Configuring IP SLA MPLS LSP Ping and Trace Operations