Cisco ASR 9000 Serie

DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enables or disables a PM statistics collection template.Do one of the following:
Step 2
•
performance-mgmt apply statistics
{entity | interface {basic-counters
•
Only one PM statistics collection template for a given entity can be enabled
at a time.
| data-rates | generic-counters} type
•
You must specify either a location with the location keyword and node-id
argument or the location all keywords when enabling a PM statistic
collections for these entities:
interface-path-id } [ location {all |
node-id}] {template-name | default}
•
no performance-mgmt apply
statistics {entity | interface
◦
Node CPU
{basic-counters | data-rates |
◦
Node memory
generic-counters} type
◦
Node process
interface-path-id } [location {all |
node-id}]
The location keyword with the node-id argument enables PM statistic
collections for the specified node. The node-id argument is expressed in
Example:
the rack/slot/module notation. The location all keywords enable a PM
statistic collection for all nodes.
•
Because only one PM statistics collection can be enabled for any given
entity at any given time, you are not required to specify the template name
RP/0/RSP0/CPU0:router(config)#
performance-mgmt apply statistics
mpls ldp default
with the default keyword or template keyword and template-name argument
when disabling a PM statistics collection.
or
Data collection will begin one sampling cycle after you enable the PM
statistics collection template with the performance-mgmt apply
statistics command.
Note
RP/0/RSP0/CPU0:router(config)# no
performance-mgmt apply statistics
mpls ldp
•
When a template has been enabled, the sampling and export cycles continue
until the template is disabled with the no form of the performance-mgmt
apply statistics command.
•
You must specify either a location with the location keyword and node-id
argument or the location all keywords when disabling a PM statistic
collections for these entities:
◦
Node CPU
◦
Node memory
◦
Node process
The location keyword with the node-id argument disables PM statistic
collections for the specified node. The node-id argument is expressed in
the rack/slot/module notation. The location all keyword disables the PM
statistic collections for all nodes.
•
Because only one PM statistics collection can be enabled for any given
entity at any given time, you are not required to specify the template name
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
355
Implementing Performance Management
Enabling and Disabling PM Statistics Collection Templates