Cisco ASR 9000 Serie

SUMMARY STEPS
1.
configure
2.
Do one of the following:
•
performance-mgmt apply thresholds {entity | interface {basic-counters | data-rates |
generic-counters} type interface-path-id } [location {all | node-id}] {template-name | default}
•
no performance-mgmt apply thresholds {entity| interface {basic-counters | data-rates |
generic-counters} type interface-path-id } [location {all | node-id}]
3.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enables or disables PM threshold monitoring templates for the specified template.Do one of the following:
Step 2
•
performance-mgmt apply thresholds
{entity | interface {basic-counters |
•
Only one PM threshold monitoring template for an entity can be enabled
at a time.
data-rates | generic-counters} type
•
You must specify either a location with the location keyword and node-id
argument or the locationall keywords when enabling a PM threshold
monitoring template for these entities:
interface-path-id } [location {all |
node-id}] {template-name | default}
•
no performance-mgmt apply
thresholds {entity| interface
◦
Node CPU
{basic-counters | data-rates |
◦
Node memory
generic-counters} type
◦
Node process
interface-path-id } [location {all |
node-id}]
The location keyword with the node-id argument enables the PM threshold
monitoring template for the specified node. The node-id argument is
Example:
RP/0/RSP0/CPU0:router(config)#
expressed in the rack/slot/module notation. The location all keywords
enable the PM threshold monitoring template for all nodes.
performance-mgmt enable thresholds
node cpu location all template20
•
Because only one PM threshold monitoring template for an entity at any
given time, you are not required to specify the template name with the
or
RP/0/RSP0/CPU0:router(config)# no
default keyword or template keyword and template-name argument when
disabling a PM statistics collection.
performance-mgmt apply thresholds
node cpu location all
•
Once a template has been enabled, threshold monitoring continues until
the template is disabled with the no form of the performance-mgmt apply
thresholds command.
•
You must specify either a location with the location keyword and node-id
argument or the location all keywords when disabling a PM threshold
monitoring template for these entities:
◦
Node CPU
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
358
Implementing Performance Management
Enabling and Disabling PM Threshold Monitoring Templates