show radius client
To obtain general information about the RADIUS client on Cisco IOS XR software, use the show radius
client command.
show radius client
Syntax Description
This command has no keywords or arguments.
Command Default
The default value for the counters (for example, an invalid address) is 0. The network access server (NAS)
identifier is the hostname that is defined on the router.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
The show radius client command displays the authentication and accounting responses that are received from
the invalid RADIUS servers, for example, unknown to the NAS. In addition, the show radius client command
displays the hostname or NAS identifier for the RADIUS authentication client, accounting client, or both.
Task ID
OperationsTask ID
readaaa
Examples
The following sample output is for the show radius client command:
RP/0/RP0/CPU0:router# show radius client
Client NAS identifier: miniq
Authentication responses from invalid addresses: 0
Accounting responses from invalid addresses: 0
This table describes the significant fields shown in the display.
Table 5: show radius client Field Descriptions
DescriptionField
Identifies the NAS-identifier of the RADIUS
authentication client.
Client NAS identifier
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
82 OL-24740-01
Authentication, Authorization, and Accounting Commands
show radius client
To Next Page
Loading...
Need help?
General
