show sam certificate
To display records in the certificate table, use the show sam certificate command.
Syntax Description
Displays all the attributes for the selected table entry (specified by the
certificate-index argument).
detail
Specifies the certificates stored in a specific location. Use one of the following:
root, mem, disk0, disk1, or other flash device on router.
location
Index number for the entry, in the range from 1 to 65000.
certificate-index
Displays selected attributes for entries in the table.brief
Displays selected attributes for all the entries in the table.all
Displays selected attributes for only the certificates stored in a specific location.
Use one of the following: root, mem, disk0, disk1, or other flash device on
router.
location
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 2.0
The summary keyword was replaced with the brief keyword.Release 3.3.0
Usage Guidelines
Use the show sam certificate command when you want to display all the certificates stored in the system.
Attributes are certificate number, certificate flag, serial number, subject name, issued by, version, issuing
algorithm, not-before and not-after dates, public key, and signature.
To get the certificate number, use the certificate-index argument. When used with the brief keyword, the all
keyword displays selected attributes for all the entries in the table.
When used with the brief keyword, the location argument displays selected attributes for only the certificates
stored in a specific location. Use one of the following: root, mem, disk0, disk1, or other flash device on
router.
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
242 OL-24740-01
Software Authentication Manager Commands
show sam certificate
To Next Page
Loading...
Need help?
General
