Cisco CRS User Manual

Software Authentication Manager Commands
This module describes the Cisco IOS XR software commands used to configure Software Authentication
Manager (SAM).
For detailed information about SAM concepts, configuration tasks, and examples, see the Configuring
Software Authentication Manager on the Cisco IOS XR Software module in the Cisco IOS XR System
Security Configuration Guide for the Cisco CRS Router Software configuration module.
•
sam add certificate, page 234
•
sam delete certificate, page 236
•
sam prompt-interval, page 238
•
sam verify, page 240
•
show sam certificate, page 242
•
show sam crl, page 246
•
show sam log, page 248
•
show sam package, page 250
•
show sam sysinfo, page 253
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
OL-24740-01 233

Cisco CRS Specifications

General

Operating System	Cisco IOS XR
Product Type	Core Router
Form Factor	Modular Chassis
Dimensions	Varies by chassis type
Weight	Varies by chassis type
Architecture	Distributed
Switch Fabric	Multi-stage
Interface Support	Ethernet, SONET/SDH, OTN
Interfaces/Ports	Varies by line card
Port Density	Varies by line card
Routing Protocol	BGP, IS-IS, OSPF, MPLS
Management	CLI, SNMP
Power Supply	Redundant, hot-swappable
Cooling	Redundant, Hot-swappable Fan Trays
Supported Protocols	IPv4, IPv6, MPLS
Management Interfaces	Ethernet, console
Security Features	ACLs