aaa default-taskgroup
To specify a task group for both remote TACACS+ authentication and RADIUS authentication, use the aaa
default-taskgroup command. To remove this default task group, enter the no form of this command.
aaa default-taskgroup taskgroup-name
no aaa default-taskgroup
Syntax Description
Name of an existing task group.
taskgroup-name
Command Default
No default task group is assigned for remote authentication.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.2
Usage Guidelines
Use the aaa default-taskgroup command to specify an existing task group for remote TACACS+
authentication.
Task ID
OperationsTask ID
read, writeaaa
Examples
The following example shows how to specify taskgroup1 as the default task group for remote TACACS+
authentication:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# aaa default-taskgroup taskgroup1
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
OL-24740-01 19
Authentication, Authorization, and Accounting Commands
aaa default-taskgroup
To Next Page
Loading...
