Cisco CRS

ssh client vrf
To configure a new VRF for use by the SSH client, use the ssh client vrf command. To remove the specified
VRF, use the no form of this command.
ssh client vrf vrf-name
no ssh client vrf vrf-name
Syntax Description
Specifies the name of the VRF to be used by the SSH client.
vrf-name
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.8.0
Usage Guidelines
An SSH client can have only one VRF.
If a specific VRF is not configured for the SSH client, the default VRF is assumed when applying other SSH
client-related commands, such as ssh client knownhost, on page 272 or ssh client source-interface, on page
274.
Task ID
OperationsTask ID
read, writecrypto
Examples
The following example shows the SSH client being configured to start with the specified VRF:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# ssh client vrf green
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
276 OL-24740-01
Secure Shell Commands
ssh client vrf