show sam package
To display information about the certificate used to authenticate the software for a particular package installed
on the networking device, use the show sam package command.
show sam package package-name
Syntax Description
Location of the software package, including the memory device (disk0:, disk1:, mem:,
and so on) and the file system path to the file. Use the show install all command to
display the Install Manager package name and location information.
package-name
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 2.0
Usage Guidelines
Use the show install all command to display the installed location and name of the software package—for
example, mem:ena-base-0.0.0 or disk1:crypto-exp-lib-0.4.0—and then use the show sam package command
to display information about the certificate used to authenticate that installed package. The show sam package
command displays the same information as the show sam certificate command for the detail keyword.
Task ID
OperationsTask ID
readcrypto
Examples
The following sample output is from the show sam package command:
RP/0/RP0/CPU0:router# show sam package mem:12k-rp-1.0.0
------------------------------------------------------------
Certificate Location :mem
Certificate Index :1
Certificate Flag :VALIDATED
----------------------- CERTIFICATE ------------------------
Serial Number :01:27:FE:79:00:00:00:00:00:05
Subject Name :
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
250 OL-24740-01
Software Authentication Manager Commands
show sam package
To Next Page
Loading...
Need help?
General
