interface (MPP)
To configure a specific interface or all interfaces as an inband or out-of-band interface, use the interface
command in management plane protection inband configuration mode or management plane protection
out-of-band configuration mode. To disable all the configurations under an interface mode, use the no form
of this command.
interface {type interface-path-id| all}
no interface {type interface-path-id| all}
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
type
Virtual interface instance. Number range varies depending on interface type.
Use the show interfaces command in EXEC mode to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
Configures all interfaces to allow for management traffic.all
Command Default
None
Command Modes
Management plane protection out-of-band configuration
Command History
ModificationRelease
This command was introduced.Release 3.5.0
The management plane protection out-of-band configuration mode
was added.
Release 3.6.0
Usage Guidelines
Use the interface command to enter management plane protection inband interface configuration mode or
management plane protection out-of-band interface configuration mode.
For the instance argument, you cannot configure Management Ethernet interfaces as inband interfaces.
Task ID
OperationsTask ID
read, writesystem
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
172 OL-24740-01
Management Plane Protection Commands
interface (MPP)
To Next Page
Loading...
Need help?
General
