Cisco CRS

Examples
The following example shows how to configure all inband interfaces for MPP:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# control-plane
RP/0/RP0/CPU0:router(config-ctrl)# management-plane
RP/0/RP0/CPU0:router(config-mpp)# inband
RP/0/RP0/CPU0:router(config-mpp-inband)# interface all
RP/0/RP0/CPU0:router(config-mpp-inband-all)#
The following example shows how to configure all out-of-band interfaces for MPP:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# control-plane
RP/0/RP0/CPU0:router(config-ctrl)# management-plane
RP/0/RP0/CPU0:router(config-mpp)# out-of-band
RP/0/RP0/CPU0:router(config-mpp-outband)# interface all
RP/0/RP0/CPU0:router(config-mpp-outband-all)#
Related Commands
DescriptionCommand
Configures an interface as an inband or out-of-band
interface to allow all peer addresses for a specified
protocol or all protocols.
allow, on page 166
Configures the control plane.control-plane, on page 169
Configures an inband interface or protocol.inband, on page 170
Configures management plane protection to allow
and disallow protocols.
management-plane, on page 174
Configures out-of-band interfaces or protocols and
enters management plane protection out-of-band
configuration mode.
out-of-band, on page 175
Displays the management plane.show mgmt-plane, on page 177
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
OL-24740-01 173
Management Plane Protection Commands
interface (MPP)